Mile High RC's Outrunner Brushless Motor's

Dollar for Dollar Absolutely the Most Power for the Buck.

400XT Type A Outrunner Brushless Motor

This is an awesome direct drive Motor. A good up grade for GWS war birds and/or park flyers in the speed 400 range. Did we mention one of the best flat foam 3D motors for the buck?

This motor is comparable to the other 400XT models on the market. But un-like the other brands the shaft is easily reversible and/or replaceable. So when the landing is not so great and you break or bend a shaft you do not need to replace the bell for $10-$15. Simply replace the shaft for $3.00 instead. Recently reworked the shaft now has very close tolerances eliminating vibration, Magnets are good to 180 degrees, High speed bearings supporting the shaft on both ends. And very rare in the industry, and required by Mile High RC for all the 500 and smaller size  motors we carry, the stator is double bonded limiting stator movement on nose in landings/crashes. All leading to better efficiency and increased power.

Motor comes with 3.0mm shaft, an X mount, and screws. Does not come with bullet type connectors to plug to the ESC. Fits in to any GWS type speed 400 gear box. And has fit every 400 size aluminum/plastic outrunner type mount I have tried so far. Mounting holes are 16mm (or roughly 5/8 in.)

Aside form the awesome performance of this line of motors. They are extremely user friendly. The shaft can be moved from pusher to puller. Simply loosen an allen screw and the shaft slides out. Flip it over, tighten it back up and you  have a pusher motor. Un-like others on the market, to change the shaft you do not need to apply heat to the bell possibly causing damage to the magnets. So you can swap from pusher jet or wing to your favorite puller application with ease. More Info flipping the shaft here.

All shafts are 3.0 mm but we have 2.3mm shafts that can be swap out for you. Should you break a shaft we do carry them or, any GWS, MPI, or most any other 3.0mm shaft will fit. We suggest using a prop saver it will help reduce prop breakage and shaft bends on the not so perfect landings. Shafts, prop savers, and other parts can be found here.

400XTA : Direct Drive

Full 2 oz. Lighter then a geared 400 brushed motor.

1000kv ~ 10 apms (15 peak for 30 Sec.)

KV: 1000    Weight: 1.6oz (46g)    Diameter: 26mm    Length: 24mm    Shaft: 3.0mm (2.3 avail.)

Direct Drive Stats (Stats by us at 4,907' above sea level)

Suggested set up: Direct drive up to 9x3.8 (3-cell)  through 11x4.7 prop (2-cell).  

Video in an ME-109               Video on a Slow Stick

Please note: Motor comes with a 3mm shaft and is now Gold see this photo

  $28.00 with Free Priority Shipping

Motor is discontinued. -- See the 2830-12 for a great comparison, a little better performance, little more efficiency, and a better value.